COMPATABILITY: This optic cut is compatible with most other slide mods we offer, see specific model details below.
GLOCK (All models except G42, G41 and G17L)
This mounting package mounts a Shield RMS only, forward of the rear iron sight on Glocks, including G43's. Our mounting process inlets the optic into the slide sufficiently to allow co-witnessing with suppressor sites which we strongly recommend. Our trials have shown us that placing a red dot on top of your pistol is NOT like placing a red dot on an AR platform. If you want to find that dot fast, you need irons to guide you for speed. We have irons for sale in the Triggers and Sights section. The front and rear wall of the inlet will be cut to match the optic perfectly, as well as bosses for the forward indexing points, thereby providing additional stabilization/locating points. If you need us to install/change your iron sites, or just disassemble/reassemble your slide, please add the armorer fee to your shopping cart, that will cover the sites swap. Of course we will need the sites if you're not purchasing them from us.... If you're purchasing new irons, they must be suppressor sights to be tall enough to co-witness. This machining will expose raw steel which we recommend refinishing to prevent oxidation/rusting. We offer Cerakote and PVD options separately. We now offer a slide blank to fit this optic's inlet cut at this time for the G43.
SMITH & WESSON (M&P 9/40/9c/40c, SHIELD 9/40)
We can mount your SHIELD RMS on your S&W M&P's using the same style inlet mount as described above in the Glock section. Due to the RMS's extremely short footprint, we anticipate being able to place the optic forward of the OEM dovetail, thus eliminating the need for optional BUIS dovetail cutting. We also anticipate being able to mount the optic deep enough that standard sights should cowitness through the optic fine, thus giving the weapon a lower profile. The optic does hang over the sides on the SHIELD just a little but fits nicely.
CZ (P-07, P-09, P10c)
We can mount your SHIELD RMS on your CZ model listed above using the same cut technique described in the Glock section above. We haven't performed this modification on the P-07 and 09 yet, but we anticipate the optic may fit between the existing dovetail and ejection port, thus eliminating the need for optional BUIS requirements. It also appears that we can mount this optic low enough that standard sights will cowitness through the optic (see photos above), again, keeping your costs lower as well as the profile of the gun. On the P-10c, we have mounted the RMS forward enough to retain the rear mounted iron sight dovetail and low enough that the OEM standard sights cowitness through the optic beautifully (see photos above).